Westerbeke 9.0 BCG Technical Manual page 230

WELD A 1/2-13UNC HEX NUT
TO ONE SIDE OF THIS CENTER
1/2 DlA DRILL-TYP.
4 HOLES
MATERIAL: COLD ROLLED STEEL
HOUSING PULLER TOOL
(FIELD FABRICATED]
This tool allows the bearing in the generator
housing to be gently pushed straight off the
housing without any twisting. If a nut of the
same specifications as that of the tapped
hole in the pilot tool were to be welded on
the end of the eye
bolt,
this tool would be
able to pull the bearing back into place
without any twisting. Please refer to these
drawings before the generator end is
removed.
Westerbeke Generators
224
."
112-nUNC STORE-BOUGHT
EYE BOLT WITH TAPERED
TIP.
M12 •
1.7S PITCH
• 38 •• LONG-3 BOLTS
PROPER USE OF THE
HOUSIN6 PULLER