Mitsubishi 2010 RVR Owner's Manual page 400

Personalizing the air conditioning switch (Changing
the function setting)
You can change the following functions to match your prefer-
ence.
Enable automatic air conditioning control:
When the mode selection dial or blower speed selection
dial has been set to the "AUTO" position or when the tem-
perature control dial has been set to the minimum temper-
ature, the air conditioning switch is automatically
controlled.
Disable automatic air conditioning control:
The air conditioning switch is not automatically con-
trolled, unless the air conditioning switch is used.
Changing the settings
Press the air conditioning switch for about 10 seconds or
longer.
When the setting has changed, the system will beep and
the indicator light will flash.
• When the setting has changed from enabled to disabled,
the system will beep three times and the indicator will
flash three times.
• When the setting has changed from disabled to enabled,
the system will beep two times and the indicator light
will flash three times.
NOTE
The factory setting is "Enable automatic air conditioning
control".
N00759800045
While the mode selection dial is set between "
" " position, the air conditioning will run automatically,
even if the system is set to "Disable automatic air condi-
tioning control", in order to prevent windows from fog-
ging up.
Comfort controls
" and
5
5-31