Mitsubishi 2010 RVR Owner's Manual page 306

Confirmation function setting
®
The Bluetooth 2.0 interface is equipped with a confirmation
function.
With the confirmation function activated, you are given more
opportunities than normal to confirm a command when making
various settings to the Bluetooth
you to decrease the possibility that a setting is accidentally
changed.
The confirmation function can be turned on or off by following
the steps below.
1. Press the SPEECH button.
2. Say "Setup."
3. Say "Confirmation prompts."
4. The voice guide will say "Confirmation prompts are
<on/off>. Would you like to turn confirmation prompts
<off/on>."
Answer "Yes" to change the setting or answer "No" to
keep the current setting.
5. The voice guide will say "Confirmation prompts are
<off/on>" and then the system will return to the main
menu.
Security function
It is possible to use a passcode as a security function by setting
a passcode of your choice for the Bluetooth
When the security function is turned on, it is necessary to make
a voice input of a 4-digit passcode in order to use all functions
®
of the Bluetooth 2.0 interface, except for reception.
N00564500019
®
2.0 interface. This allows
N00564600023
®
2.0 interface.
Setting the passcode
Use the following procedure to turn on the security function by
setting a passcode.
1. Press the SPEECH button.
2. Say "Setup."
3. Say "Passcode."
4. The voice guide will say "Passcode is disabled. Would
you like to enable it?" Answer "Yes."
Answer "No" to cancel the setting of the passcode and
return to the main menu.
5. The voice guide will say "Please say a 4-digit passcode.
Remember this passcode. It will be required to use this
system."
Say a 4-digit number which you want to set as a passcode.
6. For confirmation purposes, the voice guide will say "Pass-
code <4-digit passcode>. Is this correct?" Answer "Yes."
Answer "No" to return to the passcode input in Step 5.
7. When the registration of the passcode is completed, the
voice guide will say "Passcode is enabled" and the system
will return to the main menu.
NOTE
Passcode will be required to access the system after the
next ignition cycle.
It is required for a little time after engine stop that the
entered passcode is actually recorded in the system.
If the ignition switch or the operation mode is made to
ACC or ON or the engine is started immediately after
engine stop, there is a case when the entered passcode is
not recorded in the system. At this time, please try to enter
the passcode again.
Features and controls
3
3-209