Mitsubishi 2010 RVR Owner's Manual page 125

Features and controls
On vehicles equipped with continuously variable trans-
mission (CVT), do not stop the engine with the selector
lever in any position other than the "P" (PARK) position.
If the engine is stopped with the selector lever in any posi-
tion other than the "P" (PARK) position, the operation
mode will go to ACC rather than OFF.
Put the operation mode in OFF after placing the selector
lever in the "P" (PARK) position.
1. Stop the vehicle.
2. Fully engage the parking brake while depressing the brake
pedal.
3. On vehicles with a manual transaxle, press the engine
3
switch to stop the engine, and then move the gearshift
lever to the 1st (on a uphill) or "R" (Reverse) (on a down-
hill) position.
On vehicles equipped with continuously variable trans-
mission (CVT), move the selector lever to the "P"
(PARK) position, and then press the engine switch to stop
the engine.
If the F.A.S.T.-key is not operating properly
Insert the F.A.S.T.-key into the key slot in the glove box. Start-
ing the engine and changing the operation mode should be now
possible.
Remove the F.A.S.T.-key from the key slot after starting the
engine or changing the operation mode.
3-28
NOTE
Do not insert into the key slot anything other than the
F.A.S.T.-key. This could cause damage or a malfunction.
Remove the object or additional key from the F.A.S.T.-
key before inserting the key into the key slot. The vehicle
may not be able to receive the registered ID code from the
registered key. Therefore, the engine may not start and the
operation mode may not change.
N00568300015
F.A.S.T.-key reminder
If the operation mode is in OFF and the driver's door is opened
with the F.A.S.T.-key in the key slot, a warning is issued with