Battery Installation And Replacement - Dog trace d–control 600 Service Instructions Manual

Battery installation and replacement

INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER (COLLAR)
Remove 4 screws of the receiver housing cover plate with a cross-head screwdriver. Install
the 3V lithium CR2 battery. Mind the correct polarity indicated on the receiver PCB with
"+" symbol in the battery compartment (see the photo).
A beep indicating correct installation of battery will sound.
If you do not hear the beep after installation of the battery, remove it immediately.
Check the polarity and try to install it again.
Before putting the plate cover to its place make sure that the rubber seal is correctly
seated in its slot. Tighten adequately the 4 screws on the cover plate of the receiver.
WARNING: Before replacing the battery, always turn off the receiver, take out the
battery and use a metal object to short-circuit the battery contacts (e.g. using
screwdriver, scissors, etc.).
Checking the battery power
To check the state of the transmitter battery, look at the LCD display:
The battery is fully charged: The battery indicator is
slowly fl ashing green when in on-state.
Low battery: The battery indicator is blinking red
when in on-state. Prepare a spare 3V lithium battery
CR2 and follow the section "Installation of the battery
in the receiver".
Make sure that the receiver operates correctly.
6
Battery polarity symbol