Battery Installation And Replacement - Dog trace Dog Balls User Manual

Battery installation and replacement

Installation (replacement) of the battery in the ball machine
● Remove the screw from the ball machine battery space cover with a cross-head screwdriver.
Take the battery holder out carefully. Insert 4 LR6 AA 1,5V batteries. Mind the polarity
marked on the battery holder.
● Before putting the battery space cover back to its place make sure that the battery holder
is seated in the battery space correctly. Tighten the screw on the battery space cover
using adequate force.
Battery space cover
Checking the battery status
Look at the indicator light on the front panel of the ball machine to check the battery status:
● The battery is fully charged: the LED indicator blinks slowly in green in on-state.
● The battery is weak: the LED indicator blinks in red in on-state. Prepare a spare 3V lithium
battery CR2 and follow the section describing the battery installation. Make sure the ball
feeder works correctly.
TIP: The device can also be operated using LR6 rechargeable batteries.
Installation (replacement) of the battery in the remote controller
● Unscrew the battery space cover screw on the back side
of the remote controller and litt the cover carefully.
Insert a new 3V CR2 battery. Mind the polarity marked
on the battery cover (see the picture). Put the cover back
and tighten the screw using adequate force.
Battery holder
Battery compartment
5