Troubleshooting - Dog trace d–control 600 Service Instructions Manual

The remote controller is waterproof as much as possible. If it is dropped into water, it is likely
that it will be irrecoverably damaged or destroyed.
If you do not use the unit for a long time, remove the batteries from your remote controller
and receiver.
The collar will remember the preset confi guration (autoencoding). When you turn it on next
time, it will be in the mode you selected last time.

Troubleshooting

Before you start considering your unit to be faulty:
Read out this Service Instruction manual once again and make sure that the problem
is not caused by weak batteries or by incorrect application.
Check to see if the batteries are positioned correctly with regard to their polarity.
If a problem persists, try to initialize the system by removing the battery from the battery
holders in the receiver, then use a metal tool (e.g. a screwdriver, scissors, etc.) and
short-circuit both contacts – battery holders for about 2 seconds. Reinstall the battery.
The unit emits a beep confi rming that the battery is installed with correct polarity.
Unless this helps, program your receiver again. Clear the previous code in the memory
and then match your receiver with the remote controller according to instructions
in this manual.
If the problem persists, contact your supplier.
18