Dog trace d–control 600 Service Instructions Manual page 11

Or you can select a long pulse that will last as long as you keep pressing the button, however,
it will be limited for 8 second at most. The red LED on the receiver will glow steadily.
This will be indicated by the transmission symbol on the LCD. You can select a short pulse
(option A) or a continuous one (option B) by pressing the button to select dog 1 repeatedly;
if the other collar is used, press repeatedly the button to select dog 2.
Button – Booster (for the second selectable level of the correction pulse)
By pressing down this button, you will send your dog a warning in the form of electronic
pulses transmitted by the two electrodes located in the receiving collar, being generated all
the time you are keeping the button pressed, however, with the limit of 8 seconds at most.
The red LED on your receiver will be steadily lit.
The LCD display of remote controller will indicate the symbol of transmission along with the
correction pulse value you selected. Program the level of Booster button by holding the
pressed button for selecting Dog 1 until the LCD display starts fl ashing. Then, use the control
buttons to set the required value of the correction pulse and confi rm by
another press of the button for selecting Dog 1.
Control buttons
These buttons are used for prompt setting of the intensity of pulses in the receiving collar.
It is possible to set up 30 levels indicated by numbers 1–30 on the LCD display. When the
correction pulse level setting is changed, the LCD display will be lit for 3 seconds.
Level 0: no pulses. Level 1: weakest pulse. Level 30: strongest pulse.
Control buttons
These buttons are designed for selection of your dog.
11