Table of Contents
Advertisement
Machine Translated by Google
3. The orange indicator light on the device lights up (charging time is approx
2 hours).
4. When charging is complete, the orange light will turn off.
NOTICE: Charge the battery in an environment with a temperature of 0° to 40°C.
For charging, use a charging adapter with a voltage between 5 to 5.5 V DC or the original 5.2 V
power adapter offered by the manufacturer as an additional accessory. Using a higher voltage
adapter could damage the electronic collar.
4.3 Checking the condition of the battery
The red indicator LED on the side is used to check the status of the battery in the device (Fig. 1/4 on
page 2). If the red LED is flashing, the collar is discharged and needs to be charged. Do not leave the d-
mute ONE in a discharged state for an extended period of time.
The battery could be damaged.
4.4 Switching on / off the collar
The d-mute ONE collar is controlled using a magnetic switching system, which is activated by applying
a magnet to marked points on the device. To turn on, place the magnet (Fig. 1/5) at 0.5 s to the red
point marked M (Mode) according to Fig. 3 on page 3. A rising tone will be heard followed by one beep
indicating switching to mode 1. After turning on, the device is in energy-saving standby mode and
waiting to be activated by the dog barking.
To turn it off, hold the magnet for a long time again at the red dot on the collar marked M. The collar will
start beeping repeatedly. At the time the descending tone is heard, move the magnet away.
NOTE: It is not necessary to turn off the collar. If the dog is not barking or you are not using the
collar, it consumes very little energy from the battery.
Turn off the collar only if you do not use it for more than a month.
8
Advertisement
Table of Contents
