Hints For Using; Maintenance - Dog trace d–control 600 Service Instructions Manual

Electronic training collar electronic training collar – a set for two dogs
Hide thumbs Also See for d–control 600:
Table of Contents

Advertisement

Hints for using

Do not place your remote controller close to objects sensitive to magnetic fi elds that
might get damaged and be out of repair.
Do not put your d-control in places exposed to high temperatures.
It is necessary to replace the batteries every two years and also in the case that the set
is not used for a long time. Never leave a fl at battery in your unit; it might leak and
damage your unit.
Repeated contacts of the electrodes with the dog's skin may cause its irritation.
If this happens, do not use the collar until all traces of irritation are gone.

Maintenance

Never use volatile agents such as thinners, petrol, or various cleaners to clean your DOGtrace™
d–control. Use a soft damped cloth and a neutral clearing agent if necessary.
The receiver (collar) DOGtrace™ d–control is water-tight only on condition of a good
state of the seal and after its treatment with silicone vaseline. If this is fulfi lled, your dog
can even swim with that. In order to maintain the water-tightness of your receiver, we
recommend to replace the rubber seal under the receiver's cover and treat it with silicone
vaseline.
After every replacement of the battery in the collar, make sure that the seal is properly
cleaned and settled and that the screws are adequately tightened. Check them regularly and
tighten them only adequately!
WARNING:
In the event that your dog has a wet fur,
use a lower level of the correction pulse
than you usually use.
17

Advertisement

Table of Contents
loading

Table of Contents