Battery Installation / Replacement; How It Works - Dog trace d–mute User Manual

Battery installation / replacement

Use a cross-head screwdriver to remove the screws from the cover of the unit. Insert the
battery (3V lithium CR2). Mind the correct polarity marked inside. You will hear a sound
signal indicating that the battery is installed properly. If no sound signal comes out,
remove the battery immediately. Check the polarity and try again. If the unit does not
respond after reinstallation, the battery may be fl at or the unit faulty and it requires
professional repair.
Before the cover is replaced, make sure the sealing is properly inserted in the slot.
Tighten the screws adequately.
If you do not use the collar for a long time, remove the battery from the unit.

How it works

The system is activated automatically by dog barking, or howling. 6 modes of correction
and sensitivity of the system can be set easily. The correction is based on an audio signal
or a correction pulse, eventually on combination of both. The collar is easy to use,
compact and waterproof. It is suitable for all dog breeds and sizes. In standby mode,
the device is waiting for barking our howling. After the fi rst bark, it emits an audio signal
or an audio signal along with a correction pulse – its intensity depends on a selected
mode. If your dog keeps barking, the device responds again in the same way.
The process can be repeated 5 times at the most and then it is stopped automatically.
15 seconds after, the system is switched back into standby mode and is ready to
respond to barking again.
6