Battery Installation And Replacement - Dog trace d–control easy Service Instructions Manual

Battery installation and replacement

INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER (COLLAR)
Remove 4 screws of the receiver housing cover plate with a cross-head screwdriver. Install the 3V
lithium CR2 battery. Mind the correct polarity indicated on the receiver PCB with "+" symbol in the
battery compartment (see the photo).
A beep indicating correct installation of battery will sound.
If you do not hear the beep after installation of the battery, remove it immediately. Check the
polarity and try to install it again.
Before putting the plate cover to its place make sure that the rubber seal is correctly seated in its
slot. Tighten adequately the 4 screws on the cover plate of the receiver.
Checking the battery state
Look at the indicator on the front panel of the receiver (collar) to check the state of battery:
The battery is fully charged: When on-state, the LED fl ashes slowly in green.
The battery is fl at: When on-state, the LED fl ashes red. Prepare a spare 3V lithium battery CR2 and
follow the section describing how to install the battery in the receiver.
Make sure that the receiver works correctly.
6
Battery polarity indication