Related Manuals for Dog trace d-control easy mini
Summary of Contents for Dog trace d-control easy mini
- Page 1 d-control easy mini Elektronisches Erziehungshalsband Electronic training collar Collare elettronico di addestramento Collier électronique de dressage Elektronische trainingshalsband...
- Page 2 IČO: 64793826 declare under own responsibility that the product: Electronic training collar Dogtrace d-control easy mini is in compliance with the essential requirements and other relevant provisions of Directivem 2014/53/EC, meets requirements of General Licence of The Czech telecommunication office according to general licence no.
- Page 3 Before using your product, please read the instructions in this user guide carefully and keep it for future reference. VNT electronics s.r.o., hereby declares that the Dogtrace electronic training collar d-control easy mini complies with the basic requirements and further relevant regulations of directive 2014/53/EC.
-
Page 4: Table Of Contents
Contents Important notice ................27 ECMA . -
Page 5: Important Notice
Important notice The electronic training collars d-control are intended only to train animals. They are not intended to harm, injure or to cause fear. Do not use the electronic training collars for dogs with health problems (e.g. heart disease, epilepsy, etc.) or for dogs with behavior disorders (aggressive dogs etc). The collar should never be worn for more than 12 hours a day. -
Page 6: Ecma
ECMA VNT electronics s.r.o., professional producer of the dog training equipment, which is manufactured and sold under the brand name Dogtrace, is a proud and active member of the Electronic Collar Manufacturers Association. ECMA was founded in Brussels in 2004 as a result of increasing awareness from different manufacturers concerning the necessity of regulating their industry. -
Page 7: Introduction
It is possible to easily adjust the intensity of the stimulation. The electronic training collar d-control easy mini is suitable especially for small dogs, thanks to its small dimensions and low weight of the receiver. Its control is very simple; there are six different stimulation levels of lower intensity and an audible beep tone available. -
Page 8: Product Description
Product description REMOTE CONTROLLER RECEIVER WITH THE STRAP REMOTE CONTROLLER 1 – Sound signal button 2 – Buttons to select stimulation impulse 1 - 6 3 – ON/OFF power switch 4 – Indicator RECEIVER WITH THE STRAP 1 – Woven strap 2 –... -
Page 9: Battery Installation And Replacement
Battery installation and replacement INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER (COLLAR) Screw out 4 screws from the battery cover using a cross-head screwdriver and remove the lid. Insert the lithium CR2 3V battery into the battery compartment with a correct polarity (according to the polarity indicated with the “+”... - Page 10 INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE REMOTE CONTROLLER Screw out screw from the battery cover using a cross-head screwdriver and carefully remove the lid. Insert a new lithium battery CR2 3V into the battery compartment with a correct polarity (according to the polarity indicated with the “+”...
-
Page 11: Turning On/Off
Turning ON/OFF TURNING THE REMOTE CONTROLLER ON/OFF Turning on: Press down for 1 second the ON/OFF button on the remote controller. Turning on is indicated by a sound signal and by a flashing green LED. Turning off: Again, press down for 1 second the ON/OFF button . -
Page 12: Programming (Pairing) Of The Transmitter And The Receiver
IMPORTANT: When turning the receiver ON hold the red target of the receiver close to the red target of the transmitter for about 1 second. When the targets are close to each other for longer than 5 seconds the receiver will switch to the pairing (programming) mode of the transmitter with the receiver. -
Page 13: How To Use The Remote Controller
How to use the remote controller The Dogtrace d-control easy mini remote controller is designed for interaction with one receiver. Button – sound signal When you press down the sound signal button, you will be able to send the sound signal to your receiver within a great distance. -
Page 14: How To Check That Your D-Control Works Correctly
How to check that your d-control works correctly You can check anytime whether your set works correctly. Before the check, make sure that the receiving collar is turned off. Connect the leads of the testing discharge lamp to both contact points (loosen up the contact points, insert the wires of the lamp under them so that they can be firmly held and then retighten the contact points). - Page 15 If you hold your remote controller in front of you with your hand reached out, the range will get longer. Before using your training set, always check the batteries in the remote controller and in the collar and replace them if necessary. The power of batteries slightly falls down at temperatures below 0 °C.
-
Page 16: We Are Starting With The Training Collar
We are starting with the training collar The trainer’s elementary knowledge of the dog training is the prerequisite for using the training collar. If you don´t have this knowledge, we recommend you to contact a training center, a cynology club, or a school for dogs where you will learn the basic communication with your dog. You can start using the collar for the 6 months old dog, which have undergone the basic training and is familiar with basic obedience commands including „sit“, „down“, „stay“... - Page 17 Send a sound warning to your dog when it is doing something inappropriate. Catch the attention of your dog… Teach it that this signal means ”To me“, ”Come“ commands, wherever your dog is (the sound signal replaces your dog-whistle). The sound signal forgoing the pulse is very efficient; Your dog will soon create a link between its incorrect behaviour, the sound warning, and its unpleasant feeling.
-
Page 18: Tips
Do not place your remote controller close to objects sensitive to magnetic fields that might get damaged and be out of repair. Do not put your d-control easy mini in places exposed to high temperatures. It is necessary to replace the batteries every two years and also in the case that the set is not used for a long time. -
Page 19: Maintenance
Maintenance It is important to keep the device clean. Never use volatile substances eg.: thinner, gasoline or other cleaners. To clean your d-control easy mini use a soft, damp cloth and neutral detergent if necessary. The receiver (collar) is waterproof only on condition of the good state of the seal. We recommend you to replace the rubber seal, which is placed under the cover of the battery compartment of the receiver, once a year. -
Page 20: Technical Specifications
Technical specifications Transmitter Range ................200 m Power supply . -
Page 21: Warranty Terms And Conditions
Warranty terms and conditions VNT electronics s.r.o. provides a 2 year warranty on the Dogtrace products with respect to defects in material and workmanship under normal use and service from the date of the original purchase. The limited warranty does not cover the following: batteries straps direct or indirect risks during transportation of the product to the retailer... - Page 22 4. The claimant is obliged to prove the defect and to enable the manufacturer to check the legitimacy of the product faults and assess the extent of the product faults. Otherwise is loosing the right arising from the manufacturer’s responsibility for product defects. 5.