How To Use The Remote Controller - Dog trace d–control 600 Service Instructions Manual

REPROGRAMMING OF YOUR RECEIVER
The receiver can be programmed repeatedly without restraint using the same remote controller
or another (see the section Programming (matching) of your remote controller and receiver).
TIP
It is possible to program an unlimited number of receivers to one receiver, which is
possible for common training of several dogs. It is possible to record two transmitters
into one receiver which can be used by the instructor for instance, for potential
correction of dressur.

How to use the remote controller

The DOGtrace™ d–control remoter controller is designed for interaction with two separate
receivers independent of each other.
Button – Sound signal
When you press down the sound signal button, you will be able to send the sound signal to
your receiver within a great distance. There is no time limit for this function: The buzzer will
sound for as long as you are holding the pressed down button and the green LED on your
receiver will be steadily lit. It will be indicated by the transmission symbol on the LCD display
of your remote controller.
Button – Short pulse or Permanent pulse – (Selection A/B)
By pressing this button, you will send your dog a warning in the form of an electronic pulse
transmitted by the two electrodes located in the receiving collar for a defi ned period of time.
You can select if you want to use a pulse shorter than 1 second (regardless of how long you
are pressing down the button). However, it is necessary to keep the button pressed for one
second at least. The red LED on your receiver will glimpse.
10