Table of Contents
Advertisement
Battery installation and replacement
INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER (COLLAR)
Screw out 4 screws from the battery cover using a cross-head
screwdriver and remove the lid.
Insert the lithium CR2 3V battery into the battery compartment
with a correct polarity (according to the polarity indicated
with the "+" symbol in the battery compartment – see the
Fig.). A wrong polarity may damage the unit.
When you insert the battery for the first time, or if the battery is
removed longer than a few tens of minutes, you will hear an
audible beep tone indicating the correct installation of the
battery.
Make sure that the rubber seal is clean and correctly seated in
its groove. Clean any dirt from the seal.
Put the battery cover of the receiver back and screw in the
4 screws adequately.
Note: When you replace the battery quickly, you may not hear the audible beep tone of the
collar.
Checking the receiver battery status
The status of the battery is indicated by LED indicators on the side of the receiver. (see chapter:
Product description – Receiver with the strap).
The batterry is fully charged – when switched on, green LED is flashing
The battery is low – when switched on, red and green LED is flashing
When the battery is low or flat, insert a new CR2 3V lithium battery into the receiver. Check the
correct function.
Battery polarity indicator
31
Advertisement
Table of Contents
