Receiver; Transmitter Preparation; Battery Insertion And Replacement; Checking The Transmitter Battery Status - Dog trace d-control professional 1000 mini Manual

Electronic training collar

Table of Contents

Display

1. Command indicator of function buttons

A1 or B1

2. Command indicator of function buttons

A2 or B2

3. Transmission indicator

4. Current button setup indication

5. Battery power indicator

6. Indicator of mode or stimulation level

7. Locking of selected function and command

5.2 Receiver

1. Contact points

2. Strap

3. Target (red indicator) indicating

where the ON/OFF magnetic

switch is located

4. LED indicators

1. Screw out 4 screws from the battery cover using a cross-head screwdriver and

remove the lid.

2. Insert two alkaline AAA batteries into the battery compartment with a correct

polarity (according to the polarity indicated with the "+" symbol in the battery

compartment). Wrong polarity may damage the unit.

3. Make sure that the rubber seal is clean and correctly seated in its groove.

4. Put the battery cover back and screw in the 4 screws adequately.

The battery power indicator on LCD shows the battery status:

– Fully charged battery

– Medium charged battery

– Flat battery

If the battery is flat, insert new AAA alkaline batteries into the battery compartment.

Table of Contents