Product Description; Transmitter Preparation; Battery Insertion And Replacement In The Transmitter - Dog trace 640 Instructions Manual

5
TRANSMITTER
1
6
7
TRANSMITTER – 1 – Backlit LCD display, 2 – Vibration button, 3 – Light button,
4 – Tone signal button, 5 – ON/OFF Switch, 6 – Vibration mode selection button,
7 – Dog selection button (dog 1, dog 2)
RECEIVER – 1 – Indicator area where the ON/OFF magnetic switch is located,
2 – ON/OFF LED Indicator, 3 – Contact points
DISPLAY – 1 – Indicator of the radio transmission, 2 – Battery power indicator,
3 – Stimulation intensity level indicator, 4 – Dog selection indicator (dog 1,
dog 2)
6

6.1 Battery insertion and replacement in the transmitter

1. Remove the cover of the battery compartement and insert 2 AA alcaline batteries.
Mind the correct polarity marked in the battery compartement.
2. Replace the cover and tighten the screw.
The battery power indicator on LCD shows the battery status:
– Fully charged battery
20

PRODUCT DESCRIPTION

2
3
4
5
7
6

TRANSMITTER PREPARATION

RECEIVER
1
3
1 2
3
4
2
LCD DISPLAY