Programming (Matching) Of The Remote Controller And The Receiver - Dog trace d–control 600 Service Instructions Manual

Programming (matching) of the remote controller and the receiver

Every remote controller has its own RF operational code. Programming of the remote
controller with the receiver (collar) will be accomplished during the fi rst use of the
DOGtrace™ d–control or with a new remote controller or a receiver (when one or the other
is lost). This operation will enable you to match your remote controller with the delivered
receiver (collar).
IMPORTANT: Before programming is started (before the fi rst use of your receiver
or code rewriting), make sure that no one else uses his/her d–control or another
product made by DOGtrace in your neighbourhood – your receiver could randomly
receive the code from another remote controller and set to it. If this happens,
program your receiver once again, using your remote controller.
Turn on your transmitter.
Select Dog 1 using the button on the transmitter.
Touch the lower part of your remote controller to the target on your receiver (see the
photo on page 8). The green LED will be steadily lit and after some 6 seconds, it will switch
to the programming mode, indicated by continuous fl ashing of the red LED.
Now take your transmitter away and press down the sound signal
remote controller. The codes will be matched in this step and your receiver will produce
a sound signal.
Select Dog 2 using the button on the transmitter and proceed in the same way
(it is applicable to the other collar for d–control 602, 1002, 1602 models).
button on your
9