Sntp Settings; Time Settings - D-Link Xstack DGS-3600 Series User Manual

SNTP Settings

Time Settings

To configure the time settings for the Switch, open the Administration folder. Then the SNTP Settings folder and click on the
Time Settings link, revealing the following window for the user to configure.
The following parameters can be set or are displayed:
Parameter
System Boot Time
Current Time
Time Source
SNTP State
SNTP Primary Server
SNTP Secondary
Server
SNTP Poll Interval in
Seconds (30-99999)
Year
Month
Day
Time in HH MM SS
Click Apply to implement changes made.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 18. Time Settings window
Description
Displays the time when the Switch was initially started for this session.
Displays the Current Time set on the Switch.
Displays the time source for the system.
Use this pull-down menu to Enabled or Disabled SNTP.
This is the IP address of the primary server the SNTP information will be taken from.
This is the IP address of the secondary server the SNTP information will be taken from.
This is the interval, in seconds, between requests for updated SNTP information.
Enter the current year, if you want to update the system clock.
Enter the current month, if you would like to update the system clock.
Enter the current day, if you would like to update the system clock.
Enter the current time in hours, minutes, and seconds.
Current Time
SNTP Settings
Set Current Time
42