Dhcp Auto Configuration Settings - D-Link Xstack DGS-3600 Series User Manual

The following fields can be set or viewed:
Parameter
Interface Name
Neighbor IPv6 Address
Link Layer MAC Address
After entering the IPv6 Address and MAC Address of the Static IPv6 Neighbor entry, click Apply to implement the new entry.
To return to the IPv6 Neighbor window, click the

DHCP Auto Configuration Settings

This window is used to enable the DHCP Autoconfiguration feature on the Switch. When enabled, the Switch is instructed to
receive a configuration file from a TFTP server, which will set the Switch to become a DHCP client automatically on boot up. To
employ this method, the DHCP server must be set up to deliver the TFTP server IP address and configuration file name
information in the DHCP reply packet. The TFTP server must be up and running and hold the necessary configuration file stored
in its base directory when the request is received from the Switch. For more information about loading a configuration file for use
by a client, see the DHCP server and/or TFTP server software instructions. The user may also consult the Upload screen
description located in the Maintenance section of this manual.
If the Switch is unable to complete the DHCP auto configuration, the previously saved configuration file present in the Switch's
memory will be used.
To enable the DHCP Auto Configuration State, use the pull-down menu to choose Enabled and click the Apply button.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 30. IPv6 Neighbor Settings – Add window
Description
Enter the name of the Interface associated with this entry, if any.
The IPv6 address of the neighbor entry. Specify the address using the hexadecimal
IPv6 Address (IPv6 Address is hexadecimal number, for example 1234::5D7F/32).
The MAC address of the IPv6 neighbor entry.
Show All IPv6 Neighbor Entries
Figure 6- 31. DHCP Auto Configuration Settings window
link.
52