Configure Local Enable Password; Enable Admin - D-Link Xstack DGS-3600 Series User Manual

Configure Local Enable Password

This window will configure the locally enabled password for the Enable Admin command. When a user chooses the
"local_enable" method to promote user level privileges to administrator privileges, he or she will be prompted to enter the
password configured here that is locally set on the Switch.
To view the following window, click Security > Access Authentication Control > Configure Local Enable Password:
To set the Local Enable Password, set the following parameters and click Apply.
Parameter
Old Local Enabled
New Local Enabled
Confirm Local Enabled

Enable Admin

The Enable Admin window is for users who have
logged on to the Switch on the normal user level, and
wish to be promoted to the administrator level. After
logging on to the Switch, users will have only user level
privileges. To gain access to administrator level
privileges, the user will open this window and will have
to enter an authentication
authentication methods for this function include
TACACS/XTACACS/TACACS+/RADIUS,
defined server groups, local enable (local account on
the Switch), or no authentication (none). Because
XTACACS and TACACS do not support the enable
function, the user must create a special account on the
server host, which has the username "enable", and a
password configured by the administrator that will
support the "enable" function. This function becomes
inoperable when the authentication policy is disabled.
When this window appears, click the Enable Admin
button revealing a dialog box for the user to enter
authentication (password, username), as seen below. A
successful entry will promote the user to Administrator
level privileges on the Switch.
To view the following window, click Security > Access
Authentication Control > Enable Admin:
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 11- 4 . Configure Local Enable Password window 2
Description
If a password was previously configured for this entry, enter it here in order to change it to
a new password
Enter the new password that you wish to set on the Switch to authenticate users
attempting to access Administrator Level privileges on the Switch. The user may set a
password of up to 15 characters.
Confirm the new password entered above. Entering a different password here from the
one set in the New Local Enabled field will result in a fail message.
password. Possible
user
Figure 11- 43. Enable Admin window
Figure 11- 44. Enter Network Password dialog box
277