Acl; Time Range - D-Link Xstack DGS-3600 Series User Manual

ACL

Time Range

Access Profile Table
Flow Meter
CPU Interface Filtering
Time Range
The Time Range window is used in conjunction with the Access Profile feature to determine a starting point and an ending point,
based on days of the week, when an Access Profile configuration will be enabled on the Switch. Once configured here, the time
range settings are to be applied to an access profile rule using the Access Profile table. The user may enter up to 64 time range
entries on the Switch.
NOTE: The Time Range commands are based on the time settings of the Switch.
Make sure to configure the time for the Switch appropriately for these commands
using commands listed in the following chapter, Time and SNTP Commands.
To open the Time Range window, click ACL > Time Range, which will display the following window for the user to configure.
The user may adjust the following parameters to configure a time range on the Switch:
Parameter
Range Name
Hours
Weekdays
Click Apply to implement changes made. Currently configured entries will be displayed in the Time Range Information table in
the bottom half of the window shown above.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 1. Time Range Settings window
Description
Enter a name of no more than 32 alphanumeric characters that will be used to identify this
time range on the Switch. This range name will be used in the Access Profile table to identify
the access profile and associated rule to be enabled during this time range.
This parameter is used to set the time in the day that this time range is to be enabled using
the following parameters:
•
start time <time hh:mm:ss> - Use this parameter to identify the starting time of the
time range, in hours, minutes and seconds, based on the 24-hour time system.
•
end time <time hh:mm:ss> - Use this parameter to identify the ending time of the
time range, in hours, minutes and seconds, based on the 24-hour time system.
Use the check boxes to select the corresponding days of the week that this time range is to
be enabled.
Section 10
213