D-Link Xstack DGS-3600 Series User Manual page 184

Gigabit ethernet managed switch
Hide thumbs Also See for Xstack DGS-3600 Series:
Table of Contents

Advertisement

Field
Network Mask
ToS
Metric
Autonomous Systems External Link Advertisements
Autonomous Systems (AS) link advertisements are Type 5 link state advertisements. These advertisements are originated by AS
boundary routers. A separate advertisement is made for each destination known to the router that is external to the AS.
AS external link advertisements usually describe a particular external destination. For these advertisements the Link State ID field
specifies an IP network number. AS external link advertisements are also used to describe a default route. Default routes are used
when no specific route exists to the destination. When describing a default route, the Link State ID is always set with the Default
Destination address (0.0.0.0) and the Network Mask is set to 0.0.0.0.
The format of the AS External Link Advertisement is shown below:
Field
Network Mask
E - bit
Forwarding
Address
TOS
Metric
External Route
Tag
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Description
For Type 3 link state advertisements, this indicates the destination network's
IP address mask. For example, when advertising the location of a class A
network the value 0xff000000.
The Type of Service that the following cost is relevant to.
The cost of this route. Expressed in the same units as the interface costs in
the router links advertisements.
AS External Link Advertisements
Link-State Age
Link-State Sequence Number
Link-State Checksum
E
TOS
Figure 8- 35. AS External Link Advertisements
Description
The IP address mask for the advertised destination.
The type of external metric. If the E-bit is set, the metric specified is a Type 2 external
metric. This means the metric is considered larger than any link state path. If the E-bit
is zero, the specified metric is a Type 1 external metric. This means that is
comparable directly to the link state metric.
Data traffic for the advertised destination will be forwarded to this address. If the
Forwarding Address is set to 0.0.0.0, data traffic will be forwarded instead to the
advertisement's originator.
The Type of Service that the following cost is relevant to.
The cost of this route. The interpretation of this metric depends on the external type
indication (the E - bit above).
A 32-bit field attached to each external route. This is not used by the OSPF protocol
itself.
Options
Link-State ID
Advertising Router
Length
Network Mask
Metric
Forwarding Address
External Route Tag
167
5

Advertisement

Table of Contents
loading

Table of Contents