D-Link Xstack DGS-3600 Series User Manual page 190

Parameter
Interface Name
Area ID
Router Priority (0-
255)
Hello Interval (1-
65535)
Dead Interval (1-
65535)
State
Auth Type
Password/Auth. Key
ID
Metric (1-65535)
Passive
DR State
DR Address
Backup DR Address
Transmit Delay
Retransmit Time
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Description
Displays the of an IP interface previously configured on the Switch.
Allows the entry of an OSPF Area ID configured above.
Allows the entry of a number between 0 and 255 representing the OSPF priority of the
selected area. If a Router Priority of 0 is selected, the Switch cannot be elected as the
Designated Router for the network.
Allows the specification of the interval between the transmissions of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The Hello Interval, Dead
Interval, Authorization Type, and Authorization Key should be the same for all routers on
the same network.
Allows the specification of the length of time between the receipt of Hello packets from a
neighbor router before the selected area declares that router down. An interval between 1
and 65535 seconds can be specified. The Dead Interval must be evenly divisible by the
Hello Interval.
Allows the OSPF interface to be disabled for the selected area without changing the
configuration for that area.
This field can be toggled between None, Simple, and MD5 using the space bar. This allows
a choice of authorization schemes for OSPF packets that may be exchanged over the OSPF
routing domain.
•
None specifies no authorization.
•
Simple uses a simple password to determine if the packets are from an
authorized OSPF router. When Simple is selected, the Auth Key field allows the
entry of an 8-character password that must be the same as a password
configured on a neighbor OSPF router.
•
MD5 uses a cryptographic key entered in the MD5 Key Table Configuration
menu. When MD5 is selected, the Auth Key ID field allows the specification of
the Key ID as defined in the MD5 configuration above. This must be the same
MD5 Key as used by the neighboring router.
Enter a Key ID of up to 5 characters to set the Auth. Key ID for either the Simple Auth Type
or the MD5 Auth Type, as specified in the previous parameter.
This field allows the entry of a number between 1 and 65,535 that is representative of the
OSPF cost of reaching the selected OSPF interface. The default metric is 1.
The user may select Active or Passive for this OSPF interface. Active interfaces actively
advertise OSPF to routers on other Intranets that are not part of this specific OSPF group.
Passive interface will not advertise to any other routers than those within its OSPF intranet.
When this field is disabled, it denotes an active interface.
A read only field describing the Designated Router state of the IP interface. This field many
read DR if the interface is the designated router, or Backup DR if the interface is the Backup
Designated Router. The highest IP address will be the Designated Router and is determined
by the OSPF Hello Protocol of the Switch.
The IP address of the aforementioned Designated Router.
The IP address of the aforementioned Backup Designated Router.
A read only field that denotes the estimated time to transmit a Link State Update Packet over
this interface, in seconds.
A read only field that denotes the time between LSA retransmissions over this interface, in
seconds.
173