D-Link Xstack DGS-3600 Series User Manual page 166

Adjust the following parameters and click Apply to set the new Policy Route, which will be displayed in the Policy Routing
Table.
Parameter Description
Name
Enter a name of no more than 32 alphanumeric characters that will be used to identify this policy
route.
Profile ID (1-14) Enter the Profile ID number of the Access Profile, previously created, which will be used to
identify packets as following this Policy Route. This access profile, along with the access rule,
must first be constructed before this policy route can be created.
Access ID (1-128)
Enter the Access ID number of the Access Rule, previously created, which will be used to
identify packets as following this Policy Route. This access rule, along with the access profile,
must first be constructed before this policy route can be created.
Nexthop This is the IP address of the Next Hop router that will have a direct connection to the Gateway
router connected to the Internet.
State Use the pull-down menu to enable or disable this Policy Route.
To change an existing Policy Route, click its corresponding Modify button in the Policy Routing Table, which will display the
following window to configure. This window contains the same information as the previous Add window, so the parameters carry
the same meaning.
Click Apply to implement changes made. Click
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 8- 17. Policy Routing – Add window
Figure 8- 18. Policy Routing – Edit window
Show All Policy Route Entries to return to the Policy Routing Table.
149