Protocol Vlan Port Settings - D-Link Xstack DGS-3600 Series User Manual

Protocol Value
Enter the corresponding protocol value of the protocol identified in the previous field. This value
must be stated in a hexadecimal form.
Click Apply to implement changes made.

Protocol VLAN Port Settings

The following window is used to add a Protocol VLAN Group profile to a port or list of ports and adjust the tags for incoming
untagged packets before being relayed through the Switch. To view this window, click L2 Features > Protocol VLAN >
Protocol VLAN Port Settings, which will display the following window.
The following fields may be configured:
Parameter Description
Port List Use this parameter to assign ports to a Protocol VLAN Group or remove them from the Protocol
VLAN Group. Clicking the Select All Ports check box will configure this Protocol VLAN Group to
all ports on the switch.
Action Use the pull-down menu to add or delete the following Group ID to or from the ports selected in
the previous field.
Group ID Enter the ID number of the Protocol VLAN Group for which to add or remove from the selected
ports. Clicking the Select All Groups check box will apply all Protocol VLAN groups to the ports
listed in the Port List field.
VLAN ID / VLAN
Use this field to add a VLAN to be associated with this configuration. Select the correct radio
Name button if you are using a VLAN Name or a VID (VLAN ID).
Click Apply to implement changes made. The Protocol VLAN Port Table in the bottom half of the screen will display correctly
configured ports to Protocol Group configurations, along with associated VLANs and priorities. Users may use the Port List
Search in the middle of the window to display configurations based on ports on the switch. Clicking the Show All Protocol
VLAN Port Table Entries link will display all Protocol VLAN Port Table entries.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
stated using the following Protocol Value.
•
IEEE802.3 LLC – Choose this parameter if you wish this protocol group to employ the
Link Logical Control (LLC) frame type. For this frame type, the protocol is identified by the
2-octet IEEE802.3 Link Service Access Point (LSAP) pair field in the packet header,
which is to be stated using the following Protocol Value. The first octet defines the
Destination Service Access Point value and the second octet is the Source Service
Access Point (SSAP) value.
Figure 7- 18. Protocol VLAN Port Settings window
98