Lan Line Status; Network Routing Check - Sony Ipela PCS-XC1 Operating Instructions Manual

depending on the status of the system on the
remote site.
Frame Rate
Displays the maximum frame rate of motion
pictures.
Rate
Displays in real time the number of
connected lines and their transfer rates.
Line I/F
Displays the line interface being used.
Camera Control
Displays whether the unit is ready to operate
both cameras.
H239
Displays whether the unit is ready to use the
H.239 presentation mode.
Check Code
Displays the encryption check code.

LAN Line Status

The LAN line status is displayed.
Bit rate - Encode
Displays by category (audio, video and
H.239 (presentation)) the transfer rates for
sending data.
Bit rate - Decode
Displays by category (audio, video and
H.239 (presentation)) the transfer rates for
receiving data.
Number of lost packets
Displays by category (audio, video and
H.239 (presentation)) the number of packets
lost during transfer on the network.
Number of recovered packets
Displays by category (audio, video and
H.239 (presentation)) the number of lost
packets that were recovered with the
system's QoS function.
Number of received packets
Displays by category (audio, video and
H.239 (presentation)) the number of packets
received during communication.

Network Routing Check

The Network Routing Check menu is used to
check the network routing, and it shows the
checking results.
You can start the network routing check by
selecting "Start Measurement" in the lower
part of the menu.
For details, see "About the Network Routing
Check" on page 76.
IP address of remote site
Enter the IP address of the remote terminal
you want to check.
Line I/F
LAN: Select to perform the routing check
for the network connected to the
connector.
Gateway
Displays the results of check for the default
gateway.
ping
Displays the results of check for
reachability, packet loss, RTT (Round-Trip
Time) and H.323 (H.323 communication
availability).
traceroute
Displays the results of check for HOP
(number of routers passed through to reach
the remote site) and total RTT.
Start Measurement
Select this button to start a network routing
check.
Previous
Select this button to restore the Machine
Status menu.
Displaying the Machine Status
67