Sony Ipela PCS-XC1 Operating Instructions Manual page 88

Notes
• When "Internet Protocol" is set to "IPv4" in the Administrator setup menu,
you can enter a dot (.) with the b or DOT button.
• When "Internet Protocol" is set to "IPv6" in the Administrator setup menu,
you can enter a colon (:) with the b or DOT button.
• To delete the last entered character, use the BACK SPACE button on the
Remote Commander or "Back Space" on the on-screen keyboard.
• To delete the entered IP address, use the RETURN button on the Remote
Commander or "Cancel" on the on-screen keyboard.
2 Select the communication bit rate.
Use the V, v, B or b button to select "Communication Bit Rate", then
press the ENTER button. Press the V, v, B or b button to select the
communication bit rate from the displayed submenu, then press the
ENTER button.
4
Press the CONNECT (
V, v, B or b button to select "Connect" in the lower part of the menu, then
press the ENTER button on the Remote Commander.
The system begins dialing the IP address entered in step 3. "Dialing"
appears on the monitor screen.
When the system connects to the remote system, the message "Session
Connected." appears on the screen, and the picture on the remote site is
displayed. Now you can start communication with the remote party.
To cancel dialing before connecting
While "Dialing" is displayed on the monitor screen, press the DISCONNECT
) button or the ENTER button on the Remote Commander.
(
To save the entered IP address in the Phone Book
When you enter the IP address, the Save button appears at the lower part of the
menu.
Select "Save" with the V, v, B or b button, then press the ENTER button on
the Remote Commander. The List Edit menu is displayed. Save the address or
number you entered into the Phone Book.
For details on the List Edit menu, see "Registering a Remote Party – Phone
Book" on page 92.
Redial function
Once you have input the IP address using the Detailed Dial menu, it will be
entered in the text box of the Detailed Dial menu the next time you open the
menu.
Note
The redial function is not available:
• Once you have turned off the power of the system or set it to standby mode.
• When you cancel dialing of the entered IP address.
88
Starting a Connection by Calling a Remote Party
) button on the Remote Commander, or use the