Sony Ipela PCS-XC1 Operating Instructions Manual page 82

1
Use the V, v, B or b button on the Remote Commander to select
in the Home menu, then press the ENTER button.
2
Use the V, v, B or b button on the Remote Commander to select the line
interface to be used, then press the ENTER button.
IP: Connects to the system on the remote site via a LAN connected to the
Note
When a checkmark is put to "SIP" under "Line Interface" of the Line Interface setup
menu, you can select "SIP" from the line interface select box.
3
Use the V, v, B or b button on the Remote Commander to select the
number input box, then press the ENTER button.
4
Enter the remote party's IP address with the number buttons on the Remote
Commander, then press the ENTER button.
Note
The format of the address for a SIP connection is the following:
• 4000 (number assigned by the SIP server)
• 4000@sip.com
• 192.168.1.1 (when the IP address and SIP server are not used)
5
Press the CONNECT (
V, v, B or b button on the Remote Commander to select "Dial", then press
the ENTER button.
The system begins dialing the IP address or telephone number entered in
step 4. "Dialing" appears on the monitor screen.
When the system connects to the remote system, the message "Session
Connected." appears on the screen and the picture on the remote site is
displayed. Now you can start communication with the remote party.
To cancel dialing before connecting with the remote party
While "Dialing" is displayed on the monitor screen, press the DISCONNECT
( ) button or the ENTER button on the Remote Commander.
82
Starting a Connection by Calling a Remote Party
(LAN) connector.
) button on the Remote Commander. Or use the
"Line I/F"
Picture on the local site
Picture on the remote site