Tcp/Ip Network Setup Procedures - Canon IMAGERUNNER 4570 Network Manual

TCP/IP Network Setup Procedures

To use a TCP/IP network, it is necessary to perform the following procedures.
1
3
2
3
IMPORTANT
•
It is recommended that steps 1 and 3 above be performed by the network administrator.
•
The machine or the printer option does not come with printer driver software that can be
used on a UNIX platform. (Use LPD to set up a printer in UNIX.)
•
To print from a Macintosh, see Chapter 6, "Using an AppleTalk Network (Macintosh)."
•
As this product does not come with fax driver software for the UNIX platform, it is not
possible to send a fax from a UNIX platform.
•
Use the control panel of this machine or NetSpot Device Installer if you are configuring
the protocol settings for the first time. After configuring the protocol settings, you can
change the content by using the Remote UI or NetSpot Console.
3-2

TCP/IP Network Setup Procedures

Protocol Settings (See "Protocol Settings," on p. 3-3.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
NetSpot Device Installer (Canon utility)
•
NetSpot Console (via a web browser) (Canon utility)
Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/
Sending a Fax (Windows/UNIX)," on p. 3-53.)
Specify the settings for each computer you use for printing or sending a fax. (You can only print or send a fax
from a computer if the optional equipment is installed. For the equipment needed, see "Optional Equipment
and System Environment Requirements," on p. 1-2.)
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 3-72.)
Specify the settings of the computer receiving data sent from the machine. (You can only send data if the
optional equipment is installed. For the equipment needed, see "Optional Equipment and System
Environment Requirements," on p. 1-2.)