Table of Contents
Advertisement
30
Installation
In the Package
See the packing list to make sure that you have everything and that individual components are not
damaged.
Installing the Blade Assembly Unit
This subsection includes installation instructions for mounting the blade assembly unit into a
standard 19-inch rack assembly.
This subsection also describes the removal procedures.
The blade assembly unit can be installed on the proper rack provided by NEC or several third
vendors. (Each third vendor's rack must conform to the EIA standard. In addition, the rack should be
equipped with the blade assembly unit. Contact the service representative for details.)
Observe the following instructions to use the blade assembly unit safely. Failure
to follow these instructions may result in death or serious personal injury. See
pages 1 to 8 for details.
Observe the following instructions to use the blade assembly unit safely. Failure
to follow these instructions may cause a fire, personal injury, or property
damage. See pages 1 to 8 for details.
Do not use any rack which does not conform to the relevant standard.
Do not use the blade assembly unit in any unapproved place.
Do not lift the blade assembly unit with less than four persons present.
persons.
Always install the blade assembly unit in the specified place.
Do not install the blade assembly unit on the rack leaving the cover or fan
unit removed.
Do not pinch your finger with mechanical components.
Do not apply load to the blade assembly unit if it is pulled out from the rack.
Do not carry the blade assembly unit by the fan units and cable tray.
WARNING
CAUTION
Advertisement
Table of Contents
