Table of Contents
Advertisement
Installation, Relocation, and Storage
Never attempt to lift the blade assembly unit if less than four persons are
present.
The blade assembly unit weighs up to 67 kg (depending on its hardware
configuration). To avoid personal injury, four or more persons are required to
carry the blade assembly unit. Hold the blade assembly unit firmly by its bottom.
Do not hold the front bezel to lift the blade assembly unit. The front bezel may
disengage from the blade assembly unit, causing personal injury.
Do not install the blade assembly unit in any place that does not meet the
specified requirements.
Do not install the blade assembly unit in the following places or any place other
than specified in this User's Guide. Failure to follow this instruction may cause a
fire.
Do not use the equipment in a place where corrosive gases exist.
Make sure not to locate or use the server in the place where corrosive gases
(sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone,
etc) exist.
Also, do not set it in the environment where the air (or dust) includes
components accelerating corrosion (ex. sulfur, sodium chloride) or conductive
metals. There is a risk of a fire due to the corrosion and the short-circuits of an
in
Do not use the blade assembly unit if the covers and/or fan unit is removed.
Do not use the blade assembly unit if the covers and/or the front and rear fans
in the blade assembly unit are removed. Failure to follow this recommendation
may decrease the cooling effect within the unit, causing a malfunction but also
let dust enter the unit, generating fires and/or electric shocks.
Do not pinch your finger with rails or other components.
Be careful not to catch your fingers between a rail and another mechanical part,
or to get them cut by a rail at installation or removal of the blade assembly unit
from the rack.
Be careful not to drop the Blade Assembly Unit.
Hold the bottom of the Blade Assembly Unit securely when you install or
remove it from the rack. The rack mounting brackets do not have any
stopper/lock mechanism. Accordingly, if the Blade Assembly Unit is pulled out
f
rom the rack entirely, it will drop, causing possible injuries.
Do not apply any load on the blade assembly unit when it is pulled out from the
rack.
Do not apply any load on the blade assembly unit when it is pulled out from the
rack. Doing so bends the frame of the blade assembly unit. Consequently, the
blade assembly unit cannot be pushed back into the rack. Placing an object on
the blade assembly unit may also cause personal injury if the blade assembly
unit should drop.
a dusty place
an unstable place
ternal printed board.
WARNING
a humid place such as near a boiler
a place exposed to direct sunlight
9
Advertisement
Table of Contents
