Chapter Twelve: System Initialization; Initialization; Default Program Restore; Clear User Codes - Electronics Line Infinite Prime Installation Manual

Chapter Twelve: System Initialization

The Initialization menu offers a number of options that enable you to reset the system.
This menu is particularly useful when re-installing a control system at a new site. The
Initialization function clears the entire system. This restores programming defaults, clears
the log, user codes and the transmitter register. Options are also available that enable
you to clear a specific section of the system's memory separately.

12.1: Initialization

The Initialization function clears the entire system and resets factory defaults. If your
system does not include multi-default and multi-language support, skip steps 2 and 3 of
the following procedure.
To initialize the control system:
1. From the Programming menu, select Initialize, Init All [971]; the
system prompts you for confirmation.
2. For firmware versions that include multi-default and multi-language
support, select the set of programming defaults that you want to load.
3. For firmware versions that include multi-default and multi-language
support, select the required interface language.
4. Press
event log is cleared, user codes and wireless transmitters are deleted.
During system initialization, recorded vocal messages (Message Center and Home ID)
are not deleted.

12.2: Default Program Restore

Loading the system's default program enables you to restore the factory-set
programming defaults.
To load the default program:
1. From the Programming menu, select Initialize, Load Defaults [972];
the system prompts you for confirmation.
2. Press

12.3: Clear User Codes

Clear User Codes deletes all programmed user codes and restores the default Master
and Installer codes.
To clear user codes:
1. From the Programming menu, select Initialize, Clear Users [973]; the
system prompts you for confirmation.
3. Press
are restored.
to confirm; factory programming defaults are restored, the
to confirm; factory programming defaults are restored.
to confirm; all user codes are deleted and default codes
-84-