Electronics Line Infinite Prime Installation Manual page 82

11.2.6: Telephone Control
Via SMS or DTMF, you can send commands to the system in order to control various HA
units. This option allows you to enable or disable this feature for each HA unit.
To program the telephone control option for an HA unit:
1. From the Programming menu, select HA Programming, HA Units [961].
2. Select an HA unit (01-16).
3. From the HA unit's sub-menu, select TEL CTRL [#08].
4. Select Enabled or Disabled.
11.2.7: Randomize
When the system is fully armed between the hours 9:00pm and 6:00am, the Randomize
feature turns HA units on and off at random. This gives the impression that the house is
occupied and acts as a deterrent against potential intruders.
To program an HA unit to be included in the Randomize feature:
1. From the Programming menu, select HA Programming, HA Units [961].
2. Select an HA unit (01-16).
3. From the HA unit's sub-menu, select Randomize [#09].
4. Select Enabled or Disabled.
11.2.8: Pulse Time
The Pulse Time determines the manner in which an HA unit responds to the On
command. You can program each HA unit switch on momentarily. This means that, on
receiving the On command, the unit will be switched on for a programmed amount of time.
For example, you can program the hall light to switch on for 1 minute and automatically
switch itself off. Alternatively, the HA unit can be programmed to toggle on and off.
To program the Pulse Time for an HA unit:
1. From the Programming menu, select HA Programming, HA Units [961].
2. Select an HA unit (01-16).
3. From the HA unit's sub-menu, select Pulse Time [#10].
4. Select 5 sec, 30 sec, 1 min, 2 min or Toggle.
11.2.9: Descriptor
You can assign a 16-character descriptor for each HA unit. These descriptors help the
user to identify the various HA units installed around the home.
To edit an HA unit descriptor:
1. From the Programming menu, select HA Programming, HA Units [961].
2. Select an HA unit (01-16).
3. From the HA unit's sub-menu, select Descriptor [#11].
4. Edit the descriptor using the alphanumeric keypad.
5. Press when you have finished editing.
-82-