Vocal Message Dialer - Electronics Line Infinite Prime Installation Manual

To program the number of Report Cycles:
1. From the Programming menu, select Communications, Accounts,
Report Cycles [9518].
2. Enter a value between 01 and 03.
3. Press when the desired setting is displayed.
In the example illustrated in Figure 10.1, Account 1 is programmed with 2 call attempts,
Account 2 is programmed with 3 call attempts and the number of report cycles
programmed is 3.

10.3: Vocal Message Dialer

The Vocal Message Dialer is a feature that calls the user's telephone number when
specific events occur and plays pre-recorded messages. These calls are made after the
system has reported the events to the central station. Additionally, in the event of an
alarm, the user is able to establish a Two-Way Audio connection on receiving the vocal
message in order to check the premises.
The system supports three Vocal Message (VM) accounts. Each account has its own
telephone number, communication interface and Two-Way Audio options.
The types of event that are reported using the Vocal Message Dialer feature are determined
in VM Event Options – see 10.10: Vocal Message Dialer Event Options. If one of these
events occurs, the control system dials the phone number for VM Account 1.
The availability of the Vocal Message Dialer feature is hardware dependent.
The sequence for a vocal message call is as follows:
1. An event occurs and the control system calls the telephone number of
VM Account 1.
2. When the user answers the call, the Home ID message and the
relevant event message are played.
Figure 10.1: Typical Report Cycle Sequence
-68-