Punch Regist Loop Size Adjustment - Konica Minolta bizhub c650 User Manual

Utility mode
– Check that the horizontal position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 7 through 10.

Punch Regist Loop Size Adjustment

When printing with a Punch setting, the angle of punched holes along the side of the paper can be adjusted.
Note
[Punch Regist Loop Size Adjustment] appears only if optional punch kit or the Z folding unit is installed
with the finisher.
For details on the Punch settings, refer to "Punching holes in copies (Punch settings)" on page 2-65.
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Setting screen, refer to "Displaying the Administrator
Settings screen" on page 11-37.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [7 Punch Regist Loop Size Adjustment].
The Punch Regist Loop Size Adjustment screen appears.
6
Touch the desired keys.
– If the Z folding unit is installed, [Z-Fold Punch Unit] appears.
7
Check the angle of the punched holes.
– If the punched holes are angled, touch [-] to change the adjustment. If the angle cannot be adjusted
by touching [-] or if the paper is wrinkled, touch [+] to change the adjustment.
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The angle of the punched holes is adjusted.
If no adjustment of the angle of the punched holes was necessary in step 7, this completes the
procedure.
C650
11
11-59