SoundCraft Si Impact User Manual page 73

DSP ELEMENTS
GE
Press to assign the 14 high
An output channel (Mix Bus, Matrix Bus, LR / Mono bus masters) must be selected for this button to have any
effect.
GE
Press to assign the 14 low
An output channel (Mix Bus, Matrix Bus, LR / Mono bus masters) must be selected for this button to have any
effect.
ON e
Lighted red to indicate an active (non- ero)
This ON button mode is only active while GEQ is assigned to the faders.
CLR
ero all bands in the active
Hold CLR and press either the GEQ HI or GEQ LO buttons to 'zero' (set to 0dB) all bands (both high and low).
FADER
Adjust the level of the assigned
The GEQ scale is shown on the left of the fader - +/-15dB, above and below a centre detented 0dB position. GEQ
FaderGlow is Red. The centre frequency of each band is shown in the Channel Name LCD.
User Manual
RAPHIC E ( E )
HI
E
LO
E
GE
E .
bands (800H - 16 H ) to the Control Channel Faders.
bands (31H - 630H ) to the Control Channel Faders.
E band. Press to ero that band.
E band.
7.4: DSP ELEMENTS
7.4: GRAPHIC EQ (GEQ)
RAPHIC E ( E )