SoundCraft Si Impact User Manual page 104

10.1.1: REVERB PARAMETERS
User Manual
LE ICON F REVERBS REVERB PARAMETERS
S e
Adjust the contour of the reverberation envelope.
With Shape all the way down, reverberation builds explosively, and decays quickly. As Shape is advanced, rever-
beration builds up more slowly and sustains for the time set by Spread. With Shape in the middle, the build-up
and sustain of the reverberation envelope emulates a large concert hall (assuming that Spread is at least halfway
up, and that Size is 30 meters or larger).
S e
Adjust reverb onset and sustain.
Low Spread settings result in a rapid onset of reverberation at the beginning of the envelope, with little or no
sustain. Higher settings spread out both the build-up and sustain.
Di Di si n
Initial echo density.
High settings of Diffusion result in high initial echo density, and low settings cause low initial density. In a re-
al-world situation, irregular walls cause high diffusion, while large flat walls cause low diffusion. For drums and
percussion, try using higher Diffusion settings.
B ss Bst B ss B st
to Low Rt).
The amount of boost or cut required is highly dependent on the material being processed.
RT Hi C t Re e Time Hi C t
It does not attenuate the reflections. High frequencies are often rolled off with this parameter, resulting in more
natural-sounding reverberation. Setting a low frequency for this parameter can actually shorten the reverb time,
as it damps the audio as it recirculates.
Hi C t
Higher frequency settings increase high frequency response, creating brighter reverbs; lower frequency settings
create darker reverbs with more bass frequency emphasis.
Hi C t
Higher frequency settings increase high frequency response, creating brighter reverbs; lower frequency settings
create darker reverbs with more bass frequency emphasis.
10.1.1: LE ICON F REVERBS REVERB PARAMETERS