Appendix 01: No Sound - SoundCraft Si Impact User Manual

NO SOUND
A T les tin G i e.
pearing at an output. There are many possible reasons for this, but the best way to troubleshoot it is to
A e S l s in ti e?
in the SOLO menu.
A e t e C nt l C
You can check which Control Channel is controlling which Input Channel in the FADER SETUP menu (See 3.2.1).
You can check which physical input is patched to an Input Channel by selecting the relevant Control Channel. The Input Patch menu
item (INPUTS from main Touch Screen Menu) will show the currently patched physical input. See reference 5.1 for more patching detail.
Is t e e n t in
The Input channel metering comes after the Mic/Line input but before the rest of the Input Channel. Therefore, if the input signal is
valid, the input is patched correctly, you have selected the correct Control Channel (SEL button), and you have applied enough Gain,
you should see a level indication on the meters in the IN section of the Assignable Channel Strip (7.2.1).
Output Channel metering is tapped just before the physical output patch.
A e t e in
You can check if phase is an issue by switching the Phase by 180 degrees on ONE of those channels (use the PHASE button for that
audio channel in the IN section of the ACS - 7.2.1). If the audio comes back, then look for the cause of the phase issue - it may be that a
balanced connection has been wired incorrectly, for example.
User Manual
nnel, In t C nnel, n In
n t e mete s?
se ?

APPENDIX 01: NO SOUND?

t P t e t?
APPENDI 01: NO SOUND
-
-