SoundCraft Si Impact User Manual page 131

NO SOUND
Is t e G te s t?
It is possible for an incorrectly set
This happens most often when the threshold is set too high and the signal never gets loud enough to 'open' the Gate. You can easily
check this by turning the Gate process off with the GATE button in the GATE section of the ACS (7.2.2).
I t e e is n Inse t P int ssi ne , is t e si n l et ne ?
The easiest way to check is to check the INSERT page from the Touch Screen Main menu. If the problem channel has an Insert Point
assigned, check that both the Insert Send and Return for that Insert Point have valid patches and that the signal is being returned
(from an external processor, for example). Reference section 5.1 has specific information on Insert patching.
Is t e C nnel n n
The basic ON button operation is described in section 7.3, while Mute Groups are covered in section 8.1.
Is t e F e ?
pre-fader, then this will not affect anything.
You can check the Pre/Post routing of any Mix Bus from an Input Channel in the INPUTS menu - Per Mix Post/Pre (6.1.1).
Is t e nnel nne t
If a signal is panned to the right and no right output exists - either because it isn t patched, or because there is
another problem with the right-hand path - then no signal will be heard.
Set Pan to the middle to make sure this isn't a problem.
User Manual
ate process to stop all signal.
nm te ?
li t t?
APPENDIX 01: NO SOUND?
APPENDI 01: NO SOUND