SoundCraft Si Impact User Manual page 48

CHANNELS & BUSSES
LCR P n Wi t
Set the proportion of centre channel signal sent to Left And RIght.
Adjust the pan law when in LCR mode is active to increase/decrease the contributions to the LR and Mono buses
when panning.
Set Mi Sen s P e P st
Set the pre/post routing for all contributions to this Mix Bus.
This setting can override settings made in the Input Channel Setup. The options are Post Fade, Post EQ, or Pre Dyn.
C nt i
Choose a pan mode for all contributions to this bus.
The bus must be set to Stereo Width for this setting to be active. Choose from Independent Pan Control, Bus Follows
Channel Pan (contributions to this bus will be panned the same as each input channel's Pan control), or Bus Inverts
Channel Pan (Contributions to this bus will be panned opposite to each channel's Pan control).
O t t P t
Touching the value fields will bring up the standard Patching setup on the Touch Screen. Two outputs can be
allocated, with individually patchable left and right connections. For more detail, please see section 5 - Inputs &
Outputs.
User Manual
MI OUTPUTS
ti n P n M e
in
6.2.1: CHANNELS & BUSSES
6.2.1: MIX OUTPUTS SETUP
SETUP
MI OUTPUTS OUTPUTS SETUP