SoundCraft Si Impact User Manual page 107

10.2.1: DELAY PARAMETERS
User Manual
LE ICON F DELA S DELA PARAMETERS
Sme
Duc ing attenuation amount.
Available only for Tape and Reverse Delays, this parameter controls the amount of "smear," or signal degradation
and frequency loss. The higher the setting, the more each delay repeat loses intelligibility compared to the original
signal.
R ti T R ti
Controls the Tap ratio of left and right outputs relative to the Delay time.
Specific to the Pong Delay effect, this controls the delay time offset between left and right taps, expressed as a
ratio of left to right time difference. In the centre the taps have the same time (1:1).
S T S
Swaps the delay time tap offset set by the Tap Ratio.
Specific to the Pong Delay effect - reverses the offset set by the Tap Ratio control.
De t M l ti n De t
Control the intensity of modulation, or depth in the Modulated Delay.
Lower settings produce a more subtle chorus effect, while higher values give a more lush chorusing of the delay
repeats.
P n T P n
Mi
Ratio of et to Dry signal.
100% is fully wet (effect) signal; 0% is fully dry (original) signal.
10.2.1: LE ICON F DELA S DELA PARAMETERS