CHANNELS & BUSSES
These offer channel naming, isolate, LR / LCR panning and routing Pre/Post routing options, width (stereo/
mono) and physical output patching.
N me
Name the selected Mix Bus.
When the Name field is selected, a QWERTY keyboard will appear on the Touch Screen so you can enter the desired
name.
Is l te
Isolate the Mix Bus Master Channel from automation playbac .
When a new cue is loaded, this channel will not be affected and its setting will not be changed. However, current
channel settings are still stored when a cue is stored.
Mi Wi t
Select Mono or Stereo width for this Mix Bus.
Note, only Mix busses 7-14 can be switched to stereo. Mix busses 1-8 are mono only.
P n M
Set Pan mode for this channel to LR (Left Right) or LCR (Left Centre Right).
Routing/Panning for the Main Mix Bus. In LCR mode the Main Mono Mix Bus is used as the Centre channel. Mono
routing must be enabled in the ACS (Assignable Channel Strip) OUTPUT section for this to work.
User Manual
MI OUTPUTS
e
6.2.1: CHANNELS & BUSSES
6.2.1: MIX OUTPUTS SETUP
SETUP
MI OUTPUTS
OUTPUTS SETUP