Update Firmware - Panasonic KX-HCM230 Operating Instructions Manual

Update Firmware

Update Firmware window allows the user to install the latest version of the
Network Camera internal operating system. In most cases, this will never be
necessary. The present firmware has undergone extensive testing and was found
to be very reliable. Changes may be necessary to accommodate new operating
systems or new web browsers that are not shown on Page 10. In those cases,
Update Firmware would be available from Network Camera Technical Support
Site at http://www.kmelink.net/ipproducts/ww/. Please check the current
firmware version on the Setup Page on Page 48.
Notes
• Do not turn off the power during Update Firmware. If the operation of
Update Firmware is stopped, please refer to Section
5.4 Troubleshooting.
• Buffered Images are erased when performing Update Firmware.
1.
Download the proper firmware from the Network Camera Technical Support
Site mentioned above.
2.
If the Network Camera is accessible from the Internet, temporarily disable the
access and connect the Network Camera to the PC as the following figure.
This will eliminate any interruption during the Update Firmware.
(Without Ethernet hub, you should use category 5 cross cable.)
or
or
Note
When the Network Camera uses the DHCP function, please change the
Internet connection from DHCP to Static in Network window. Please refer
to Page 52 for the network parameters.
3.
Access the Setup Page by entering "http://IP Address:Port No./config.html"
on the web browser and press [Enter].
• When port no. is 80 (default), you do not need to enter port no.
Ethernet hub
(Category 5 straight cable)
Broadband Router
Operating Instructions
83