Hardware Installations And Upgrades; Before You Begin; Tools And Supplies Needed; System References - Intel SC5650-DP Service Manual

2

Hardware Installations and Upgrades

This document provides instructions for adding and replacing chassis components. For
instructions on replacing components on the server board, such as the processor and
memory DIMMs, see the instructions provided with the server board.

Before You Begin

Before working with your server product, review the important safety information listed
in Appendix A, "Safety

Tools and Supplies Needed

•
Phillips* (cross head) screwdriver (#1 bit and #2 bit)
•
Needle-nosed pliers
•
Anti-static wrist strap and conductive foam pad (recommended)
•
Hex nut driver (6 mm)

System References

All references to the left, right, front, top, and bottom assume the reader is facing the front
of the chassis as it would be positioned for pedestal operation.

Removing and Installing the Left Side Cover

Warning: This chassis must be operated with the left side cover installed to ensure proper cooling.

Removing the Left Side Cover

The Intel
ensure proper cooling. You must remove the left side cover to add or replace components
inside of the platform. Before removing the left side cover, power down the server and
unplug all peripheral devices and the AC power cable.
Note: You may need a non-skid surface or a stop behind the chassis to prevent the chassis from
sliding on your work surface.
1. Observe the safety and ESD precautions listed in
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord(s).
®
Intel Chassis SC5650-DP/WS/BRP/UP Service Guide
Information".
®
Server Chassis SC5650 must be operated with the left side cover in place to
Appendix A, "Safety Information".
13