Removing A Fixed Hard Drive; Figure 31. Re-Installing Pci Card Guide - Intel SC5650-DP Service Manual

Hardware Installations and Upgrades
15. Re-install the PCI card guide. Insert tabs on the left side of PCI card guide into slots in
chassis (see letter "A" in the following figure). Swing PCI card guide into chassis
until right-side blue tabs snap into place (see letter "B").
16. Re-install any PCI add-in cards that were removed. For instructions, see
PCI Add-in
17. Re-install the front bezel assembly. For instructions, see
Assembly"
18. Re-install the left side cover. For instructions, see
19. Plug all peripheral devices and the AC power cable back into the server. Power up the
server.

Removing a Fixed Hard Drive

Caution: Fixed drives are NOT hot-swappable. Before removing or replacing the drive, you must
first take the server out of service, turn off all peripheral devices connected to the system,
turn off the system by pressing the power button, and unplug the AC power cord from the
system or wall outlet.
1. Observe the safety and ESD precautions listed in
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see
4. Remove the front bezel assembly. For instructions, see
Front Bezel
30

Figure 31. Re-installing PCI Card Guide

Boards".
Assembly".
A
"Installing the Front Bezel
"Installing the Left Side Cover"
Appendix A, "Safety
"Removing the Left Side
"Removing and Installing the
®
Intel Chassis SC5650-DP/WS/BRP/UP Service Guide
B
TP01735
"Installing
Information".
Cover".