Installing And Removing Pci Add-In Boards; Installing Pci Add-In Boards; Figure 39. Installing 5.25-In Drive Emi Shield (Dp/Ws/Brp Configuration Shown) - Intel SC5650-DP Service Manual

Hardware Installations and Upgrades
6. If reinstalling a new CD-ROM or DVD-ROM drive, see
CD-ROM Drive"
and front bezel filler panel, if available.

Figure 39. Installing 5.25-in Drive EMI Shield (DP/WS/BRP configuration shown)

7. Reinstall the front bezel assembly. For instructions, see
Assembly".
8. Reinstall the chassis cover. For instructions, see
9. Reconnect all peripheral devices and the AC power cable(s). Power up the server.

Installing and Removing PCI Add-in Boards

The following instructions describe how to install and remove a PCI add-in board in the
®
Intel Server Chassis SC5650. These instructions depend on the server board. See your
server board documentation to determine PCI add-in board compatibility.
Caution: Do not overload the server board by installing add-in boards that draw excessive current.
Caution: PCI add-in boards can be extremely sensitive to electric static discharge (ESD) and
always require careful handling. After removing the add-in board from its protective
wrapper or from the server board, place it component side up on a grounded, static-free
surface or conductive foam pad. Do not slide the add-in board over any surface.

Installing PCI Add-in Boards

Note: Before installing any PCI add-in boards, you may want to install an operating system.
1. Observe the safety and ESD precautions listed in
2. Power down the server and unplug all peripheral devices and the AC power cable.
36
for instructions. If not replacing the drive, reinstall the EMI shield
®
Intel
"Installing a DVD-ROM or
TP02048
"Installing the Front Bezel
"Installing the Left Side
Appendix A, "Safety
Chassis SC5650-DP/WS/BRP/UP Service Guide
Cover".
Information".