Installing An Additional Hot Swap Power Supply Module (Brp Configuration Only); Figure 63. Removing Power Supply Filler Panel; Figure 64. Inserting Additional Hot Swap Power Supply Module - Intel SC5650-DP Service Manual

Installing an Additional Hot Swap Power Supply Module (BRP
configuration only)
Note: This install procedure only applies to a chassis with redundant power supply capability.
DO NOT perform this install procedure if your chassis has a fixed power supply.
Warning: Hazardous conditions, power supply: Hazardous voltage, current, and energy levels are
present inside the power supply. There are no user-serviceable parts inside it; servicing of
the power supply should be done only by technically qualified personnel.
1. Observe the safety and ESD precautions listed in
2. Insert finger into hole in middle of filler panel and remove filler panel from chassis.
.
3. Insert new hot swap power supply module until it clicks into place.

Figure 64. Inserting Additional Hot Swap Power Supply Module

®
Intel Chassis SC5650-DP/WS/BRP/UP Service Guide
UP

Figure 63. Removing Power Supply Filler Panel

Hardware Installations and Upgrades
Appendix A, "Safety
AF002947
Information".
51