Inside the Laminator
The SD460 system has one standard laminator, in the L1 position, with an optional second
laminator in the L2 position. The laminators apply topcoat or patch overlay material to the card.
Topcoat is a continuous film and patch is a die‐cut polyester shape. Both laminators can apply
either overlay type. Refer to "Laminator Overlay Materials" on page
Manual Advance
Knobs
L1 Laminator
Manual Advance Knobs
L1 Laminator (green
cartridge)
L2 Laminator (orange
cartridge)
Laminator Access Door
L2 Transport Access Door
A-4
L2 Laminator
Laminator Access
Door
The manual advance knobs move the card through the
laminator to remove it from the system. Use the knobs to clear
a card jam.
The L1 laminator cartridge holds overlay material and applies
it to the card.
The L2 laminator cartridge holds overlay material and applies
it to the card. The L2 laminator is optional.
The access door provides access to the L1 and L2 laminators to
load supplies or to clear a card jam.
The L2 transport access door replaces the L2 laminator
cartridge if the optional L2 laminator is not installed. Open the
door to access the laminator card transport.
A‐6.
L2 Transport
Access Door
SD460 Laminating System