Clean the Laminator
Clean the laminator when at least one laminator cartridge is loaded with holographic overlay
material and any of the following are true:
Particles appear on the laminated cards.
Particles are visible inside the laminator.
For examples of problems that require laminator cleaning, refer to "Laminator Problems" on
page
49.
This procedure uses a double‐sided, sticky cleaning card that removes holographic
overlay particles from the laminator. When you clean the SD460 system using a regular
cleaning card, the card also moves into the laminator and cleans the laminator rollers,
card entry area, and the impresser exit rollers. This is sufficient if you are not using
holographic overlay. Refer to "Run a Printer Cleaning Card" on page
1.
Open the laminator access door and remove the L1 and L2 laminator cartridges.
2.
Remove printed cards from the output hopper, if necessary.
A-12
30.
SD460 Laminating System